The price of the power press is an important factor to consider. If the price of the machine is lower than the average price of the industry, buyers should remain vigilant. Without mass production (such as production line production), low price does not mean low profit, but represents low cost, and low cost will directly affect the life and use of power presses.
(1) The power press slider stops at the bottom dead center. At this time, in order to prevent the mold from sticking, etc., the height of the slider can be appropriately increased, and then the slider is stopped at the bottom dead center;
(2) Press the stop button of the main motor of the power press, the main motor stops running, and at the same time, the flywheel brake brakes the flywheel to stop;
(3) Stop the lubrication system;
(4) Cut off the power of the operation power press and remove the key of the operation switch;
(5) Cut off the power supply;
(6) Close the main gas source shut-off valve and drain the condensate water in the air pipeline system;
(7) Comprehensively inspect the power press for cracks, fever, damage, looseness, etc .;
(8) Clean up all parts of the power press;
(9) Sorting tools and site.
