The power press will inevitably wear and renew during use. It is too wasteful to replace the new equipment just because of the wear of the parts. In fact, at this time, only the power press parts need to be replaced to restore the machinery as new.
The specific replacement cycle, frequency, and possibility of damage of power press accessories depend on the time, purpose, and usage of people. If the single stroke is used, the damage frequency of the power press parts is high, and the continuous use will be better. The period varies greatly, and it is difficult to say the exact time.
In addition, the wear of power press parts is also closely related to the working load of the press, and the full load must be damaged quickly.
In addition to the replacement of power press parts, people should pay attention to the protection measures of power presses in daily production and life, and set up protective plates around the mold; the mold safety protection device should not increase labor intensity.
Equipped with a power press in and out device to replace the manual in and out method, isolate the operator's hands from the danger zone of the die, and implement work protection.
